Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

The content theft deterrent (CTD) system is a software based system in which the body control module (BCM) actively monitors certain inputs to determine if unauthorized vehicle access is being attempted. Based on inputs such as the door ajar switches, and the Trunk ajar switch, the BCM determines whether a CTD alarm is warranted. If unauthorized access is being detected, the BCM will pulse the vehicle horn and flash the turn signals as a means of theft deterrent.

The scan tool Last Alarm Caused, 2nd to Last Alarm Caused, and 3rd to Last Alarm Caused parameters may be used to assist in the diagnosis of an intermittent condition.

Schematic Reference

Theft Deterrent System Schematics

Connector End View Reference

Theft Deterrent System Connector End Views

Description and Operation

Content Theft Deterrent (CTD) Description and Operation

Electrical Information Reference

Scan Tool Reference

1. Ignition ON, while opening and closing each vehicle door, verify that the applicable scan tool door ajar switch parameter cycles between Door Closed and Door Ajar.

⇒	If the scan tool parameter does not cycle between the specified values, refer to Door Ajar Indicator Malfunction .

2. While opening and closing the rear compartment lid, verify the TRUNK AJAR message Illuminated on the DIC when open and off when closed.

⇒	If the message does not display properly, refer to Trunk Ajar Indicator Malfunction .

3. Completely lower the driver door window.
4. Ignition OFF, arm the CTD system using the keyless entry system by pressing the transmitter LOCK button twice. Verify the scan tool CTD Status parameter displays Armed.

⇒	If the parameter does not equal the specified value, refer to Keyless Entry System Inoperative .

5. Without disarming the system, reach in through the open driver window, unlock and open the driver door. Verify the scan tool Content Theft Mode parameter displays Warn Away or Alarm.

⇒	If the parameter does not equal the specified value, replace the BCM.

6. With the door open, verify the vehicle horn is pulsing and the turn signal lamps are flashing.

⇒	If the horn is not pulsing, refer to Horns Inoperative .

⇒	If the turn signal lamps are not flashing, refer to Turn Signal Lamps and/or Indicators Inoperative .

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for BCM replacement, setup and programming.