Preliminary Procedure

Place folding top into service position. Refer to Folding Top Retainer Strap Installation Position .

1

Roof Retract Flipper Door Cable Assembly

Tip
Support front outer closeout panels, as they may rotate without cable attached.

2

Roof Retract Flipper Door Cable Clip (Qty: 2)

3

Front Folding Top Storage Compartment Closeout Panel Retainer Pin

Tip
Remove the C-clip from the retainer pin.

4

Front Folding Top Storage Compartment Closeout Panel Bolt (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
9 N·m (80 lb in)

5

Front Folding Top Storage Compartment Closeout Panel Assembly

Tip

1. If replacing panel assembly, transfer all necessary components as needed.
2. Cycle the folding top a few seconds at a time to ensure that the tonneau is moving properly and not hanging up or interfering with the top.
3. After the installing the outer panel, adjust as needed. Refer to Folding Top Storage Compartment Closeout Panel Adjustment - Front .