Step | Action | Yes | No | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Interior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views, Computer/Integrating Systems Connector End Views or Power Door Systems Connector End Views | |||||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |||||||||
2 | Verify that the courtesy lamps are inoperative. Do the courtesy lamps operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | ||||||||
3 | Inspect for the following related body control module (BCM) module data parameters. Refer to Scan Tool Data List and Scan Tool Data Definitions for typical values and definitions:
Was a problem found? | Go to Step 6 | Go to Step 4 | ||||||||
4 | Connect a test lamp between the supply voltage and ground circuits of the inoperative lamp and activate the lamp. Does the test lamp illuminate? | Go to Step 11 | Go to Step 5 | ||||||||
5 | Test the supply voltage and ground circuits of the inoperative lamp for an open or high resistance. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 13 | Go to Step 9 | ||||||||
6 | Disconnect and test the switch of the affected input circuit for proper continuity in the open and closed positions. Refer to Circuit Testing. Does the switch operate properly? | Go to Step 7 | Go to Step 8 | ||||||||
7 | Test the signal and ground circuits of the affected input circuit for the following:
Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 13 | Go to Step 9 | ||||||||
8 | Inspect for poor connections at the harness connector of the affected switch. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 13 | Go to Step 10 | ||||||||
9 | Inspect for poor connections at the harness connector of the BCM. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 13 | Go to Step 12 | ||||||||
10 | Replace the switch in the affected circuit. Refer to one of the following replacement procedures as applicable: Did you complete the replacement? | Go to Step 13 | -- | ||||||||
11 | Replace the inoperative bulb. Refer to the correct replacement procedure. Did you complete the repair? | Go to Step 13 | -- | ||||||||
12 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 13 | -- | ||||||||
13 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 | ||||||||
