GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the front door trim panel. Refer to Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  3. Remove the rear run channel from the door. Refer to Window Channel Replacement .

  4. Object Number: 333946  Size: SH
  5. Remove the lock rods from the lock.
  6. Remove the electrical connectors from the lock (1).
  7. Remove the lock rod guide from the door lock (1).
  8. Remove the screws that retain the lock (1) to the door.
  9. Remove the lock (1) from the door.

Installation Procedure


    Object Number: 333946  Size: SH
  1. Install the lock (1) to the door.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screws that retain the lock (1) to the door.
  4. Tighten
    Tighten the retaining screws to 10 N·m (89 lb in).

  5. Install the lock rod guide to the door lock (1).
  6. Install the electrical connectors to the lock (1).
  7. Install the lock rods to the lock (1).
  8. Install the rear run channel to the door. Refer to Window Channel Replacement .
  9. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  10. Install the front door trim panel. Refer to Door Trim Panel Replacement .