GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Tracker - 2WD 🢒 HVAC 🢒 Heating, Ventilation and Air Conditioning 🢒 Air Conditioning Compressor Bracket Replacement

Air Conditioning Compressor Bracket Replacement 2.0L

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable.
  2. Remove the cooling fan drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
  3. Remove the 2 bolts (1) and the cooling fan drive belt tensioner. Refer to Drive Belt Tensioner Replacement in Engine Mechanical.
  4. Remove the A/C compressor and position aside. Do not discharge the refrigerant system. Refer to Compressor Replacement .

    5. Object Number: 640789 Size: SH
  5. Remove the 4 bolts (2) and the A/C compressor mounting bracket from the vehicle.

Installation Procedure

    Object Number: 640789 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the A/C compressor mounting bracket to the vehicle. Secure the bracket with the 4 bolts (2).

    2. Tighten
    Tighten the 4 bolts to 23 N·m (17 lb ft).

  2. Install the A/C compressor. Refer to Compressor Replacement .
  3. Install the cooling fan drive belt tensioner. Refer to Drive Belt Tensioner Replacement in Engine Mechanical.
  4. Install the cooling fan drive belt. Refer to Drive Belt Replacement in Engine Mechanical.
  5. Connect the negative battery cable.