Removal Procedure
- Remove the battery ground negative cable.
- Remove the instrument panel carrier. Refer to Instrument Panel Carrier Replacement .
- Remove the electrical connectors.
- Remove the fuse block from the tie bar (6), by pressing the retainer (3) and pushing.
- Remove the wire terminals from the fuse block (1).
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the terminals and wires to the fuse block (1).
- Install the fuse block (1) to the instrument panel.
- Install the fuse block to the tie bar (6).
- connect the electrical connectors.
- Install the battery ground negative cable.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
