Cigar Lighter Housing Replacement Chevrolet

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

•	Air bag deployment

•	Personal injury

•	Unnecessary SIR system repairs

In order to avoid the above conditions, observe the following guidelines:

•	Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.

•	If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

1. Remove the cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
2. Disconnect the electrical connector.
3. Remove the base from the retainer (4).
4. Turn the base counterclockwise.
5. Remove the lighter housing (3) from the trim plate (1).

1. Install the lighter housing (3) to the trim plate (1).
2. Install the base to the retainer (4).
3. Connect the electrical connector.
4. Install the instrument panel cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .

Cigar Lighter Housing Replacement Pontiac

1. Remove the IP carrier. Refer to Instrument Panel Carrier Replacement in instrument panel.



2. Compress the tabs (1) on the trim ring from inside the lighter housing using a flat bladded tool.



3. Push the lighter housing forward.
4. Disconnect the electrical connector.

1. Connect the electrical connector.
2. Install the lighter housing to the instrument panel trim ring  (1).
3. Install the lighter assembly.
4. Install the IP carrier. Refer to Instrument Panel Carrier Replacement in instrument panel.