Tools Required

J 39232 Wiper Transmission Separator

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the plenum chamber water deflector. Refer to Plenum Water Deflector Replacement in Body Front End.
3. Remove the three bolts and the wiper drive system module from the vehicle.
4. Disconnect the electrical connector from the wiper motor.



5. Remove the wiper transmission from the wiper motor crank arm using the J 39232 .



6. Remove the cap from the wiper transmission.
7. Remove the four screws and the wiper transmission from the tube frame.

Tools Required

J 39529 Wiper Transmission Installer

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the wiper transmission onto the tube frame with the four screws.

Tighten
Tighten the screws to 9 N·m (79 lb in).

2. Install the cap onto the wiper transmission.



3. Install the wiper transmission onto the wiper motor crank arm using the J 39529 .
4. Connect the electrical connector onto the wiper motor.



5. Install the wiper drive system module onto the vehicle with the three bolts.

Tighten
Tighten the screws to 10 N·m (88 lb in).

6. Install the plenum chamber water deflector. Refer to Plenum Water Deflector Replacement in Body Front End.
7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
8. Operate the wipers and inspect for proper operation.