Tools Required

J 41227 Sleeve Remover

1. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.



3. Remove the snap ring from axle.



4. Remove the stub axle seal.



5. Remove the sleeve from the stub axle. Use the J 41227
6. Inspect the sleeve for excessive wear, scratches or nicks that may cause a leak or damage to the seal portion. Replace the sleeve if the sleeve appears to be damaged.

Tools Required

J 41228 Sleeve Installer

1. Use the J 41228 in order to install a new sleeve on the stub axle shaft. Ensure that the collet is located in the snap ring groove when installing.



2. Install the new stub axle seal.



3. Install one new snap ring on the output shaft.
4. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
5. Lower the vehicle.
6. Inspect the output axle shaft sleeve for leaks.
7. Inspect the transmission oil level. Refer to Transmission Fluid Check