Control Valve Lower Body and Upper Body Replacement. Cadillac STS 2006

For 1990-2009 cars only

Makes 🢒 Cadillac 🢒 2006 🢒 STS 🢒 General Information 🢒 General Information 🢒 Control Valve Lower Body and Upper Body Replacement

Callout

Component Name

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the transmission fluid pan, gasket and filter. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
Remove the electrical connector sleeve. Refer to Automatic Transmission Electrical Connector Passage Sleeve Replacement .

Manual Shaft Detent Assembly Bolt (Qty: 1)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
12 N·m (106 lb in)

Manual Shaft Detent Assembly

Tip
Ensure the manual shaft detent assembly roller is centered over the manual shaft detent lever assembly. Failure to center the roller may cause hard or no shift lever operation.

Control Valve Assembly Bolt (Qty: 6)

Procedure

•	Do not remove all the bolts in the control valve body assembly. Remove only the bolts indicated.

•	Tighten the bolts in the proper order. Refer to Control Valve Body Assembly Installation in Unit Repair manual.

Tighten
8 N·m (71 lb in)

Control Valve Assembly

Procedure

Align the manual shift shaft position switch activator slide with the detent lever guide pin during control valve body installation.

Tip

•	For control valve body disassembly, refer to Control Valve Body Assembly Disassemble in the Unit Repair manual.

•	For control valve body cleaning and inspection, refer to Control Valve Lower Body Assembly Cleaning and Inspection and Control Valve Upper Body Assembly Cleaning and Inspection in the Unit Repair manual.

•	For ball check valve locations, refer to Ball Check Valve Locations in the Unit Repair manual.

•	For control valve body assembly, refer to Control Valve Body Assembly Assemble in the Unit Repair manual.

Fluid Pump Seal Assembly

Tip
Do not reuse the seal assembly.

Fluid Pump Seal Assembly

Tip
Do not reuse the seal assembly.

Center Support Fluid Passage Seal Assembly

Tip

•	Do not reuse the seal assembly.

•	It is recommended that transmission adaptive pressure (TAP) information be reset. Transmission performance may be affected as new TAP values are learned. Reset the TAP values. Refer to Service Fast Learn Adapts .