Tools Required
J 41413-200 Evaporative Emission System Tester (EEST)
Inspection Procedure
Caution: Refer to Clean, Dry, Low Pressure Gas Source Caution in the Preface section.
Note: Proceed with the following procedure only if referenced by an evaporative emission (EVAP) diagnostic or repair procedure.
- Turn OFF the ignition.
- Remove the EVAP canister purge valve. Refer to
Evaporative Emission Canister Purge Solenoid Valve Replacement.
- Lightly tap the EVAP canister purge valve on a hard surface.
- Inspect for carbon particles exiting either of the vacuum ports.
• | If no carbon particles were detected, but a blockage was detected during a diagnostic procedure, install the original EVAP canister purge valve. Continue with the cleaning procedure. |
• | If carbon particles are found during the inspection procedure, continue with the cleaning procedure. |
• | If a diagnostic procedure directed you to replace the EVAP canister purge valve and no carbon particles were detected, replace the EVAP canister purge valve. Return to the published service procedure. |
Cleaning Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the EVAP canister. Refer to
Evaporative Emission Canister Replacement.
- Turn OFF the main valve on the
J 41413-200 System Tester
.
- Disconnect the hose from the diagnostic station pressure regulator.
- Using a section of vacuum hose, connect one end onto the EVAP pressure/purge diagnostic station pressure regulator.
- Connect the other end of the vacuum hose to the canister side of the purge pipe.
- Turn ON the main nitrogen cylinder valve and continue to discharge nitrogen for 15 seconds.
- If the nitrogen does not clear the blockage, replace the purge pipe.
- Return the EVAP pressure/purge diagnostic station to the stations original condition.
- Install a new EVAP canister. Refer to
Evaporative Emission Canister Replacement.
- Lower the vehicle.
- Install a new EVAP canister purge valve. Refer to
Evaporative Emission Canister Purge Solenoid Valve Replacement.
- Return to the diagnostic table that sent you here.