GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2008 🢒 VUE - FWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement - Exhaust

Removal Procedure
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .

    3. Object Number: 1815153 Size: SH
  3. Disconnect the engine wiring harness electrical connector (1) from the exhaust camshaft position (CMP) sensor.

    4. Object Number: 1578483 Size: SH
  4. Remove the exhaust CMP sensor bolt. (Intake CMP shown, exhaust CMP similar).
  5. Remove the exhaust CMP sensor.

Installation Procedure

    Object Number: 1578483 Size: SH

    Important: Inspect the exhaust CMP sensor for damage, replace as necessary.

  1. Lubricate the exhaust CMP sensor O-ring seal with clean engine oil.
  2. Install the exhaust CMP sensor. (Intake CMP shown, exhaust CMP similar).

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the exhaust CMP sensor bolt.

    4. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1815153 Size: SH
  4. Connect engine wiring harness electrical connector (1) to the exhaust CMP sensor.
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .