- Remove the crankshaft from the block.
- Remove the crankshaft rear oil seal from the block.
- Remove the bearing inserts from the
block.
- Remove the bearing inserts from the
bed plate.
- Clean the oil, sludge, and carbon.
- Inspect the oil passages for obstructions.
- Inspect the threads.
- Inspect the bearing journals and the thrust surfaces for the following
conditions:
| • | Overheating, discoloration |
- Inspect the corresponding bearing inserts for imbedded foreign
material. If foreign material exists, find the cause and repair it.
Important: Replace the crankshaft if cracks, severe gouges or burned spots are
found. Slight roughness may be removed with a fine polishing cloth soaked
in clean engine oil. Burrs may be removed with a fine oil stone.
- Measure the crankshaft journals. Use a micrometer or dial indicator
to measure the taper and runout. Note the result for the later selection
of bearing inserts. If not within limits, the crankshaft must be replaced.
Note the location of the main bearing high spots. If they are
not in line, the crankshaft is bent and must be replaced.
