DTC B2588. Saturn VUE

For 1990-2009 cars only

Makes 🢒 Saturn 🢒 2004 🢒 VUE - AWD 🢒 DTC 🢒 DTC B2588

Circuit Description

The body control module (BCM) turns on the park lamp relay when the ambient light sensor senses a dark condition. Battery positive voltage is supplied to the park lamp relay at all times through the PARK LAMP fuse. The BCM grounds the park lamp relay control circuit in order to activate the relay.

Conditions for Running the DTC

•	The ignition switch is in the ON position.

•	The ambient light sensor senses a dark condition (automatic lamp control (ALC) park lamps on).

Conditions for Setting the DTC

The park lamp relay control circuit is shorted to voltage for 1 second.

Action Taken When the DTC Sets

•	The BCM turns off the park lamp relay control circuit for the remainder of the ignition cycle.

•	The SERVICE indicator illuminates.

Conditions for Clearing the DTC

•	The conditions for setting the DTC are no longer present.

•	A history DTC clears after 100 malfunction free ignition cycles.

•	The BCM receives the clear code command from the scan tool.

Diagnostic Aids

If the DTC is a history DTC, the problem may be intermittent. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

Test Description

The number below refers to the step number on the diagnostic table.

Listen for an audible click when the park lamp relay operates. Command both the ON and OFF states. Repeat the commands, as necessary.

Step	Action	Yes	No
Schematic Reference: Exterior Lights Schematics
1	Did you perform the Lighting System Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Lighting Systems
2	Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, command the park lamps ON and OFF. Does the park lamp relay turn ON and OFF with each command?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Test the control circuit of the park lamp relay for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 6	Go to Step 4
4	Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 6	Go to Step 5
5	Important: Perform the set up procedure for the BCM. Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Did you complete the replacement?	Go to Step 6	--
6	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	Go to Step 2	--