Service Manual Update Regarding DTCs P0636 and P0637

The purpose of this bulletin is to update all the 2000 S-Series Chassis Service Manuals at your location.

Please obtain all the 2000 S-series Chassis Service Manuals and make necessary updates as indicated below.

1. Cross out the following pages with a marker or pen:

•	Pages 142 and 143 for DTC P0636 Steering Assist Solenoid Control Circuit Low

•	Pages 144 and 145 for DTC P0637 Steering Assist Solenoid Control Circuit High

2. Remove staple from upper corner of this bulletin.
3. Follow location instructions at the top of the remaining pages of this bulletin and update service manual.

DTC P0636 - STEERING ASSIST SOLENOID CONTROL CIRCUIT - LOW VOLTAGE

The steering electronic variable office (EVO) on DOHC engines varies the power steering pressure flow form the power steering pump. The PCM controls the steering assist solenoid by pulse width modulating (PWM) ignition voltage to the solenoid. The low side of the steering assist solenoid is tied directly to a low resistance resistor, which is tied directly to ground in the PCM. The PCM monitors the steering assist solenoid circuit for low and high voltage faults at all times (Off, On and PWM). DTC P0636 sets when the steering assist solenoid is commanded On or commanded to PWM (On-time only) and the feedback voltage at the PCM is low.

DTC P0636 will set if the steering assist solenoid voltage is less than 3.0 volts when steering assist solenoid is commanded On.

DTC P0636 diagnostic runs continuously with ignition On and steering assist solenoid commanded On.

DTC P0636 is a type D DTC.

To locate an intermittent problem, use Scan tool to command STEERING ASSIST SOLENOID On. (No Assist), while monitoring the STEERING SOL. - LOW VOLT test. When a fault (short to ground or shorted solenoid) exists, the scan tool will display TEST FAIL.

The test will fail only when the device is being commanded On and the voltage at the PCM i slow. The test updates every 100 ms whenever the ignition is turned On and the device is being commanded On via the Scan tool or PCM.

Steering assist solenoid resistance: 8-12 ohms.

DTC P0637 - STEERING ASSIST SOLENOID CONTROL CIRCUIT - HIGH VOLTAGE

The electronic variable orifice (EVO) on DOHC engines varies the power steering pressure flow from the power steering pump. The PCM controls the steering assist solenoid by pulse width modulating (PWM) ignition voltage to the solenoid. The low side of the steering assist solenoid is tied directly to a low resistance resistor, which is tied directly to ground in the PCM. The PCM monitors the steering assist solenoid circuit for low and high voltage faults at all times (Off, On and PWM). DTC P0637 sets when the steering assist solenoid is commanded Off or commanded to PWM (Off-time only) and the feedback voltage at the PCM is high.

DTC P0637 will set if the steering assist solenoid voltage is greater than 3.5 volts when steering assist solenoid is commanded Off.

DTC P0637 diagnostic runs continuously with ignition On and steering assist solenoid commanded Off.

DTC P0637 is a type D DTC.

To locate an intermittent problem, use Scan tool to command STEERING ASSIST SOLENOID OFF (Full Assist), while monitoring the STEERING SOL. - OPEN or STEERING SOL. - HIGH VOLT test. When A fault (open or short to voltage) exists, the Scan tool will display TEST FAIL for both tests.

The test will fail only when the device is being commanded Off and the voltage at the PCM is high. The test updates every 100 ms whenever the ignition is turned ON and the device is being commanded Off via the Scan tool or PCM.

Steering assist solenoid resistance: 8--12 ohms.