Instrument Panel Inflatable Restraint Module Replacement RHDD

Caution: Safety precautions must be followed when handling a deployed inflator module (air bag). After deployment, the inflator module (air bag) surface may contain a small amount of sodium hydroxide, a by-product of the deployment reaction, that is irritating to the skin and eyes. Most of the powder on the inflator module (air bag) is harmless. as a precaution, wear gloves and safety glasses when handling a deployed inflator module (air bag), and wash your hands with mild soap and water afterwards.

Caution: When you are carrying an undeployed inflator module:

Important: In the event deployment has occurred, refer to Repairs and Inspections Required After a Collision .

1. Disable the SIR system. Refer to Disabling the SIR System .
2. Remove the passenger air bag harness from the cross car beam and energy absorber.



3. Remove the glove box door stops and let the glove box door hang down.
4. Remove the screws from the glove box compartment and striker.
5. Remove the glove box assembly by pulling rearward at clip locations.



6. Remove screws and the passenger side inflator module (air bag).

1. Install the passenger inflator module (air bag).

Tighten
Tighten the fasteners to 10 N·m (89 lb in).




2. Engage all inflator module wiring harness connector clips to the cross car beam and the energy absorber.



3. Install the glove box assembly and striker.
4. Install the glove box door stops.
5. Enable the SIR system. Refer to Enabling the SIR System .

Instrument Panel Inflatable Restraint Module Replacement LHD

Caution: Safety precautions must be followed when handling a deployed inflator module (air bag). After deployment, the inflator module (air bag) surface may contain a small amount of sodium hydroxide, a by-product of the deployment reaction, that is irritating to the skin and eyes. Most of the powder on the inflator module (air bag) is harmless. as a precaution, wear gloves and safety glasses when handling a deployed inflator module (air bag), and wash your hands with mild soap and water afterwards.

Caution: When you are carrying an undeployed inflator module:

Important: In the event deployment has occurred, refer to Repairs and Inspections Required After a Collision .

1. Disable the SIR system. Refer to Disabling the SIR System .
2. Remove the passenger air bag harness from the cross car beam and energy absorber.



3. Remove the glove box door stops and let the glove box door hang down.
4. Remove the screws from the glove box compartment and striker.
5. Remove the glove box assembly by pulling rearward at clip locations.



6. Remove screws and the passenger side inflator module (air bag).

1. Install the passenger inflator module (air bag).

Tighten
Tighten the fasteners to 10 N·m (89 lb in).




2. Engage all inflator module wiring harness connector clips to the cross car beam and the energy absorber.



3. Install the glove box assembly and striker.
4. Install the glove box door stops.
5. Enable the SIR system. Refer to Enabling the SIR System .