For 1990-2009 cars only
Removal Procedure
- Turn the ignition OFF.
- Remove the left side lower instrument panel (I/P) closeout panel (hush panel) push pin fasteners and remove the panel.
- Remove the left side lower heater duct assembly push pin fastener and remove the duct.
- Disconnect the cruise brake switch harness connector.
- Remove the cruise brake switch by rotating it to 180 degrees so it will pull out from the bracket.
Installation Procedure
- Pull the switch plunger all the way out to prepare for adjustment. It may require the use of moderate force.
- Connect the cruise brake switch harness connector. Push the connector in until a click is heard and pull back to confirm a positive engagement.
- Install the cruise brake switch into the bracket and rotate 180 degrees while holding the brake pedal down during installation.
- Adjust the cruise brake switch by pulling the brake pedal all the way up by hand. The switch internal ratchet mechanism will lock the switch in the adjusted position.
- Install the left side lower heater duct and push pin fastener.
- Install the left side lower I/P closeout panel (hush panel) and push pin fasteners.
Important: The notch on the plunger will be fully visible when the plunger is all the way out.
