Did you perform the Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Remote Keyless Entry

Press each button on the transmitter one at a time.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Lock and unlock the door locks using the controls inside the vehicle.

Do the locks operate properly?

Go to Step 4

Go to Diagnostic System Check - Door Systems in Doors

Operate the rear compartment release using the controls inside the vehicle.

Does the rear compartment release operate properly?

Go to Step 5

Go to Diagnostic System Check - Body Rear End in Body Rear End

Important: While viewing scan tool data and pressing and releasing each button (Lock, Unlock, Trunk and Panic) one at a time on the transmitter, the displayed data should cycle between OFF and ON.

1. Turn ignition to run.
2. Connect scan tool and select Body Control Module
3. Select Data Display.
4. Select Door Lock Data.
5. While pressing each button on the transmitter, view the RKE Lock Button, RKE Unlock Button, RKE Trunk Button, and RKE Panic Button states.

Do the states change with each button press?

Go to Step  10

Go to Step 6

1. Remove the battery from the keyless entry transmitter.
2. With a DMM, measure the battery voltage.

Is the transmitter battery voltage greater than 2.8V?

Go to Step  8

Go to Step 7

Replace the transmitter battery. Refer to Transmitter Battery Replacement .

Did you complete the replacement?

Go to Step 11

--

Replace the keyless entry transmitter.

Did you complete the replacement?

Go to Step 9

--

Perform the transmitter programming procedure. Refer to Transmitter Programming .

Was the programming procedure completed successfully?

Go to Step 11

Go to Step 10

Important: When replacing the BCM, perform the BCM programming procedure.

Replace the body control module (BCM). Refer to Body Control Module Replacement in Body Control Systems.

Did you complete the replacement?

Go to Step 11

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3