Circuit Description
The ECM checks the system voltage to make sure that the voltage stays within the proper range. Damage to components, and incorrect input can occur when the voltage is out of range. The ECM monitors the system voltage over an extended length of time. If the ECM detects an excessively low system voltage, DTC P0562 will set.
Conditions for Running the DTC
System voltage between 9.5 and 18 volts.
Conditions for Setting the DTC
| • | The ECM detects a system voltage below 10.5 Volts for 4 minutes. |
| • | Engine speed above 1,300 RPM. |
Action Taken When the DTC Sets
| • | The ECM will not illuminate the charge indicator. |
| • | The ECM will not illuminate the malfunction indicator lamp (MIL). |
| • | The ECM will store conditions which were present when the DTC set as Fail Records data only. |
Conditions for Clearing the DTC
| • | The ECM will command the message OFF after one trip in which the diagnostic test has been run and passed. |
| • | The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction. |
| • | The DTC can be cleared by using the scan tool Clear DTC Information function. |
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Connector End View Reference: Inline Harness Connector End Views in Wiring Systems or Powertrain Control Module Connector End Views in Engine Controls - 2.2L (L61) | ||||
1 | Did you perform the Engine Electrical Diagnostic System Check? | -- | Go to Step 3 | |
2 |
Does the scan tool indicate that DTC P0562 has passed this ignition cycle? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the scan tool indicate that the Ignition 1 parameter is greater than the specified range? | 10.5 V | Go to Step 7 | Go to Step 4 |
4 | Measure the voltage at the battery terminals and compare it with the Ignition 1 parameter in the ECM data list. Are the battery voltage and ECM Ignition 1 readings different by more than the value specified? | 0.5 V | Go to Step 5 | Go to Charging System Test |
5 | Test the battery positive voltage circuit of the ECM for a high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 6 |
6 | Inspect for poor connections at the harness connector of the ECM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 7 |
7 |
Important: The replacement ECM must be programmed. Replace the ECM. Refer to Powertrain Control Module Replacement in Engine Controls - 2.2L (L61). Did you complete the replacement? | -- | Go to Step 8 | -- |
8 |
Does the scan tool indicate that DTC P0562 failed this ignition? | -- | Go to Step 3 | System OK |
