The accelerator pedal position (APP) sensor system consists of two independent sensors that read differently scaled values of one another in order to command the throttle butterfly to a particular position. The APP sensor signal circuits are monitored continuously. This DTC will set if APP sensor 2 signal voltage should fall below a calibratable value.

DTC P1282 will set if APP sensor 2 signal voltage less than 0.10 volts when:

P1282 is a (type A) DTC.

To locate an intermittent problem, use the scan tool to monitor APP sensor 2 with ignition On, engine Off.

Wiggling wires while monitoring APP sensor 2 may locate the area where an open or short to ground exists.