Tools Required

J 43482 Clutch Alignment Arbor

1. Remove the transaxle from the vehicle. Refer to "Transaxle Removal" procedure in this service manual..
2. Check the slave cylinder release bearing minimal bearing drag. Replace the slave cylinder if no/little drag is found.

Notice: Remove bolts in a progressive crisscross pattern to prevent warping of the cover stamping.

3. Remove the pressure plate assembly to flywheel bolts.
4. Remove the pressure plate assembly and the clutch disc.




Important: Black random spotting on the friction surface of the pressure plate assembly is normal.

5. Inspect the pressure plate assembly surface for excessive wear, chatter marks, cracks, or overheating, indicated by blue discoloration. Replace the pressure plate assembly if damaged.
6. Check for clutch cover assembly warpage using a straight edge and feeler gage.

Specifications
Maximum warpage is 0.15 mm (0.006 in).




7. Check the clutch disc facings for oil or burnt spots. Replace the clutch disc if necessary.
8. Check the disc for loose damper springs, hub, or rivets. Replace the disc if any are broken or excessively loose.



9. Inspect the flywheel ring gear for wear or damage.  Replace the flywheel if damaged.

Important: Black random spotting on the friction surface of the flywheel is normal.

10. Check the flywheel to clutch disc contact surface for wear, cracks, chatter marks, or overheating, indicated by blue discoloration. Repair or replace the flywheel if necessary.



11. Measure the flywheel runout using a dial indicator for at least 2 revolutions. Repair or replace the flywheel if not within specification.

Specification
Maximum runout is 0.15 mm (0.0006 in).




12. Check the flywheel for warpage using a straight edge and feeler gage.

Specifications
Maximum warpage is 0.15 mm (0.006 in).




13. If the flywheel is being replaced, remove and discard the flywheel-to-crankshaft bolts and remove the flywheel.

Notice: The flywheel and flex plate bolts are not interchangeable. Ensure that flywheel bolts are used or a powertrain failure may occur.

1. Install and hand start the new flywheel-to-crankshaft bolts.

Notice: Refer to Fastener Notice in the Preface section.

2. Tighten the bolts in a crisscross pattern.

Tighten
Tighten the flywheel-to-crankshaft bolts to 53 N·m (39 lb ft) + 25 degrees.




3. Install the clutch disc and pressure plate assembly to flywheel and loosely install the pressure plate bolts.



4. Install the J 43482 in the clutch disc and push in until it bottoms out in the crankshaft.

Notice: When tightening the pressure plate assembly bolts, do not tighten any one bolt more than half a turn at a time or the pressure plate assembly may warp.

5. Tighten the bolts using a progressive crisscross pattern to prevent warping of the pressure plate assembly.

Tighten
Tighten the pressure plate-to-flywheel bolts to 15 N·m (11 lb ft).

6. Remove the clutch alignment arbor from the clutch disc.

Notice: Excessive amounts of grease on the input shaft splines can contaminate the clutch disc and cause clutch shudder.

7. Lightly lube the input shaft splines with clutch spline lubricant P/N 21005995 or equivalent.
8. Install the transaxle. Refer to " Transaxle Installation" procedure in this service manual.