Removal Procedure
- Remove the rear carpet retainer. Refer to
Rear Carpet Retainer Replacement
.
- Remove the door opening weatherstrip (1) from the door opening.
- Grasp the weatherstrip (1) and pull it from the body flange.
- Clean any adhesive from the body flange using 3M™ adhesive remover P/N 8984, or equivalent.
Installation Procedure
- Apply a small amount of weatherstrip adhesive GM P/N 12345096, or equivalent to the weatherstrip.
- Install the door opening weatherstrip by aligning the joint of the weatherstrip along the rearward portion
of the door opening. Once aligned, begin installing the weatherstrip at the top rear corner of the opening (1), and pressing the weatherstrip until fully seated.
- Finish installing the door opening weatherstrip (1) by pressing the weatherstrip into place in a clockwise direction
around the door opening.
- Install the rear carpet retainer. Refer to
Rear Carpet Retainer Replacement
.