Removal Procedure
- Remove the rear shelf trim. Refer to Rear Window Shelf Trim Panel Replacement in Interior Trim.
- Remove the interface module from the bracket by pulling back on the bracket tabs.
- Disconnect the electrical harnesses and the antenna cable.
Important: The vehicle communication interface module (VCIM) has a specific set of unique numbers that tie the module to each vehicle. These numbers, the 10-digit station identification and the 11-digit electronic serial number, are used by the National Cellular Network and OnStar® to identify the specific vehicle. Because these numbers are tied to the vehicle identification number of the vehicle, you must never exchange these parts with those of another vehicle.
Installation Procedure
- Connect the antenna cable and electrical connections to the VCIM.
- Install the VCIM into the mounting bracket.
- Install the rear shelf trim. Refer to Rear Window Shelf Trim Panel Replacement in Interior Trim.
- Reconfigure the OnStar® system. Refer to OnStar Reconfiguration .
Important: After replacing the vehicle communication interface module, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of the OnStar® system. This action will cause a DTC to set.
