Tools Required

SA9111E Hose Clamp Pliers

1. Drain the cooling system. Refer to Cooling System Draining and Filling .
2. Lower the vehicle.
3. Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Bracket Replacement in Wiring Systems.



4. Reposition the surge tank outlet hose clamp at the engine using SA9111E .
5. Remove the surge tank outlet hose from the engine.



6. Reposition the surge tank inlet hose clamp.
7. Remove the surge tank inlet hose from the surge tank.



8. Remove surge tank bolt.
9. Lift surge tank and reposition the surge tank outlet hose clamp usingSA9111E .
10. Remove surge tank outlet hose.

1. Route the surge tank outlet hose and install the surge tank outlet hose to the engine.
2. Reposition the hose clamp at the engine to secure the hose using SA9111E .



3. With the surge tank raised, install the surge tank outlet hose.
4. Reposition the hose clamp to secure the hose using SA9111E .

Notice: Refer to Fastener Notice in the Preface section.

5. Install the surge tank bolt.

Tighten
Tighten the surge tank bolt to 8 N·m (70 lb in).

6. Install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Bracket Replacement in Wiring Systems.



7. Install the surge tank inlet hose to the surge tank.
8. Reposition the hose clamp to secure the hose.
9. Fill the cooling system. Refer to Cooling System Draining and Filling .