Tools Required

J 43655 Camshaft Sprocket Holding Tool

1. Remove the camshaft position (CMP) sensor. Refer to Camshaft Position Sensor Replacement .
2. Remove the camshaft cover. Refer to Camshaft Cover Replacement .
3. Remove the upper timing chain guide.



4. Install the J 43655 .



5. Remove both the intake and the exhaust camshaft sprocket bolts and discard.
6. Slide the camshaft sprockets forward.



7. Mark the caps to ensure that the bearing caps are installed in the original position.

Important: Remove each bolt on each cap one turn at a time until there is no spring tension on the camshaft.

8. Remove the caps.
9. Remove the exhaust camshaft.



10. Remove the camshaft roller followers.



11. Remove the hydraulic lash adjusters.

1. Lubricate the valve tips.



2. Install the hydraulic lash adjusters.



3. Install the camshaft roller followers.



4. Ensure that the alignment notches are aligned with the camshaft sprocket.



5. Install the exhaust camshaft.
6. Install the camshaft caps.

Notice: Refer to Fastener Notice in the Preface section.

7. Tighten the camshaft cap bolts in increments of 3 turns until they are seated.

Tighten
Tighten the camshaft cap bolts to 10 N·m (89 lb in).

8. Install camshaft sprockets onto the camshafts.
9. Hand tighten NEW camshaft sprocket bolts.
10. Remove the J 43655 .



11. Tighten the camshaft sprocket bolts.

Tighten
Tighten the bolts to 85 N·m (63 lb ft) plus 30 degrees.




12. Install the upper timing chain guide.

Tighten
Tighten the upper timing chain guide to 10 N·m (89 lb in).

13. Install the camshaft cover. Refer to Camshaft Cover Replacement .
14. Install the CMP sensor. Refer to Camshaft Position Sensor Replacement .