Removal Procedure
- Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
- Disconnect the actuator harness from the sunroof module.
- Disconnect the electrical connectors from the actuator leads.
- Remove the screws securing the sunroof actuator to the sunroof module.
- Remove the sunroof actuator.
Important: If the sunroof window is partially closed, remove the actuator first before moving the sunroof window forward.
Installation Procedure
- Synchronize the sunroof motor to the sunroof mechanism. Refer to Sunroof Motor Synchronization .
- Install the sunroof actuator to the sunroof module.
- Install the sunroof actuator screws.
- Connect the electrical connectors to the sunroof motor/actuator.
- Secure the electrical harness to the sunroof module.
- Verify the sunroof operation.
- Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 5.5 N·m (50 lb in).
