Removal Procedure
- Remove the sunshade panel. Refer to Sunroof Sunshade Replacement .
- Remove the sunroof window. Refer to Sunroof Window Replacement .
- Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
- Disconnect the electrical connector on the sunroof actuator.
- Disconnect the electrical connector from the sunroof module.
- Disconnect the drain hoses from the drain spouts on the front sunroof.
- Disconnect the drain hoses from the drain spouts on the rear sunroof module.
- Remove the bolts that secure the sunroof module to the roof.
- Remove the 2 bolts that secure the sunroof to the roof ring.
- With an assistant, lower and remove the sunroof module assembly out through the passenger side door.
Important: A new sunroof module assembly does not include the sunroof window or the sunshade as components. You must install the old sunroof window and sunshade to the new sunroof module assembly.
Important: Remove the 2 center bolts last in order to help support the sunroof module to the roof ring.
Installation Procedure
- With an assistant, position the new sunroof module assembly into the studs located on the roof ring.
- Install the 2 center bolts which secure the sunroof module assembly to the roof and tighten the bolts by hand.
- Install the remaining sunroof module bolts.
- Connect the front and rear drain hoses to the drain spouts on the sunroof module.
- Connect the electrical connectors to the sunroof motor/actuator.
- Secure the harness to the sunroof module.
- Install the sunshade. Refer to Sunroof Sunshade Replacement .
- Install the sunroof window and loosely install the screws. Refer to Sunroof Window Replacement .
- Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment .
- Verify the proper operation of the sunroof before securing the headliner.
- With an assistant, install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten all of the bolts to 10 N·m
(89 lb in).
