For 1990-2009 cars only
Removal Procedure
- Depress the accelerator control cable tangs from the pedal lever assembly.
- Remove the accelerator control cable from the pedal lever assembly.
- Release the accelerator control cable lug (3) from the throttle body assembly (4).
- Depress the tangs on the control cable (2) while pulling the cable through the control cable bracket (1).
- Remove the control cable from the bracket.
- Disconnect the control cable (2) from the support clip (1).
- Remove the cable from the vehicle.
Installation Procedure
- Route the accelerator control cable (2) through the control cable bracket (1).
- Press the cable tabs (2) into the bracket (1).
- Install the control cable lug (3) to the throttle body cam.
- Connect the cable (2) to the support clip (1).
- Route the cable through the cowl and seat the grommet.
- Install the cable to the pedal lever assembly. Ensure the tangs are fully expanded and seated.
- Slip the accelerator cable through the slot in the rod of the accelerator pedal and install the retainer in the rod. Ensure the retainer is seated.
- Ensure the cable is completely seated in the throttle cam past the retaining clips.
- Inspect for the correct opening and closing positions by operating the accelerator pedal. Make sure that the throttle valve reaches wide-open throttle position. If not, inspect for damaged or a bent bracket or lever
Ensure the tangs expand and properly seat.
Important: Flexible components, i.e. hoses, wires, conduits, etc., must not be routed within 50 mm (2.0 in) of the moving parts of the accelerator linkage outboard support unless the routing is positively controlled.
