For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B3114 00: Remote-Key 1 Not SynchronizedDTC B3115 00: Remote-Key 2 Not Synchronized
DTC B3116 00: Remote-Key 3 Not Synchronized
DTC B3117 00: Remote-Key 4 Not Synchronized
DTC B3118 00: Remote-Key 5 Not Synchronized
Circuit/System Description
Each remote-key maintains synchronization with the steering column module (CIM). Upon each ignition transition from OFF to ON, that particular remote-key is synchronized to the CIM.
Conditions for Running the DTC
A remote-key button is pressed.
Conditions for Setting the DTC
The remote-key and CIM are not synchronized.
Action Taken When the DTC Sets
The keyless entry system is inoperative from the appropriate remote-key.
Conditions for Clearing the DTC
The DTC is cleared when the remote-key becomes synchronized with the CIM.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Keyless Entry System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Clear the DTCs.
- Ignition OFF for 60 seconds.
- Ignition ON, verify the DTC does not set.
| ⇒ | If the DTC sets, replace the appropriate remote-key. If the DTC resets, replace the CIM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for CIM replacement, setup, and programming |
