Removal Procedure
- Remove the radio.
1.1. | Disconnect with the dismantling strap, arrow. |
1.2. | Disconnect the wiring harness plug (2). |
1.3. | Disconnect the antenna (1). |
- Remove the heating/air conditioning control module.
2.1. | Loosen the 2 top clips (1). |
2.2. | Loosen the 2 bottom clips. |
2.3. | Release the 2 wiring harness plugs and disconnect (2). |
- Remove the instrument panel (I/P) center trim panel.
3.1. | Remove the 2 bolts (2). |
3.2. | Release and disconnect the wiring harness plug (1). |
3.3. | Remove the center trim panel. |
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the center trim panel.
Connect and latch the wiring harness plug.
Tighten
Tighten the 2 bolts to 2.5 N·m (22 lb in).
- Install the heating/air conditioning control module.
2.1. | Connect and lock the 2 wiring harness plugs. |
2.2. | Install the 4 clips. |
- Install the radio.
3.1. | Install the antenna. |
3.2. | Connect the wiring harness plug. |
3.3. | Slide the radio in until it clicks in. |