GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2008 🢒 Astra 🢒 Body Hardware and Trim 🢒 Instrument Panel and Console Trim 🢒 Front Floor Console Replacement

Removal Procedure

    Object Number: 1941234 Size: SH
  1. Remove the front floor console.

    2. Disconnect the 8 clips and remove the storage compartment.


    Object Number: 1941236 Size: LH
  2. Loosen the front floor console.
    3. 2.1. Place both of the seats in the most forward position.
    2.2. Remove the nut (2).
    2.3. Remove the 2 bolts (1).
  3. Disconnect the hand brake molding.

    4. Object Number: 1941237 Size: LF
  4. Loosen the front floor console and middle.
    5. 4.1. Position both seats to the rear-most position.
    4.2. Remove the 2 bolts (1), front.
    4.3. Remove the Tech2 connection molding.
    4.4. Remove the middle bolt (2).

    Object Number: 1941233 Size: SH
  5. If equipped with storage compartment, remove the storage compartment then remove the ashtray.

    6. Disconnect the 2 wiring harness plug.


    Object Number: 1941239 Size: LH
  6. Loosen the front floor console upper front.

    7. Remove the 2 bolts (2).

  7. Remove the console shift level bezel.

    8. Remove the 2 bolts (1).

    Important: Carefully take out the front floor console to the rear.

  8. Remove the front floor console.

    9. Object Number: 1948145 Size: SH
  9. If necessary, remove the cover (1) from console retaining bolt.

Installation Procedure

    Object Number: 1941287 Size: SH
  1. Position the front floor console.

    2. Slide the console in the front-most guide (1).

    Notice: Refer to Fastener Notice in the Preface section.

  2. Install the gear .

    3. Tighten
    Tighten the 2 bolts to 2.5 N·m (22 lb in).

  3. Fasten the console, upper front.

    4. Tighten
    Tighten the 2 bolts to 2.5 N·m (22 lb in).

  4. If equipped with storage compartment, install the storage compartment and then Install the ashtray.

    5. Connect the 2 wiring harness plugs.

  5. Fasten the console front and center.
    6. • Position both seats in rear-most position.

    Tighten
    Tighten the 3 bolts to 2.5 N·m (22 lb in).

    • Install the Tech2 connection molding.
  6. Install the hand brake molding.
  7. Install the console, rear.

    8. Position both seats to the most forward position.

    Tighten

        • Tighten the nut to 2.5 N·m (22 lb in).
        • Tighten the 2 bolts to 2.5 N·m (22 lb in).
  8. Install the console storage compartment, rear .

    9. Install the 8 clips.