For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC C0186 00: Lateral Accelerometer CircuitDTC C0186 1A: Lateral Accelerometer Circuit Bias Level Out of Range
DTC C0186 3B: Lateral Accelerometer Incorrect Component Installed
DTC C0186 5A: Lateral Accelerometer Circuit Plausibility Failure
DTC C0196 00: Yaw Rate Circuit
DTC C0196 1A: Yaw Rate Circuit Bias Level Out of Range
DTC C0196 3B: Yaw Rate Circuit Incorrect Component Installed
DTC C0196 5A: Yaw Rate Circuit Plausibility Failure
Circuit/System Description
The lateral accelerometer and the yaw rate sensors are combined into one sensor external to the electronic brake control module (EBCM). The vehicle stability enhancement system (VSES) uses the lateral accelerometer input when calculating the desired yaw rate. The usable output signal is a serial data signal CAN high and CAN low serial data circuits.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
| • | The yaw/lateral accelerometer sensor fails an internal self test. |
| • | Communication is lost between the EBCM and the yaw/lateral accelerometer sensor. |
| • | The correlation error between the yaw/lateral accelerometer sensor and steering angle sensor. |
Action Taken When the DTC Sets
| • | The EBCM disables the VSES for the duration of the ignition cycle. |
| • | The driver information center (DIC) illuminates the warning indicator/message. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
An incorrectly mounted sensor can cause these faults.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition On, verify that DTC C0292 is not set.
- Verify the yaw/lateral accelerometer is mounted properly.
- Replace the yaw/lateral accelerometer sensor. If the DTC resets, replace the EBCM.
| ⇒ | If the DTC is set, Refer to DTC C0292. |
| ⇒ | If not mounted properly, refer to Vehicle Yaw Sensor with Vehicle Lateral and Longitudinal Accelerometer Replacement. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for EBCM replacement, setup, and programming |
