Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B3637 A5: Rear Washer Switch StuckDTC B3638 A5: : Front Washer Switch Stuck
DTC B3639 A5: : Wiper Switch Up F 1 Stuck
DTC B3640 A5: : Wiper Switch Up F 2 Stuck
DTC B3641 A5: : Wiper Switch Down F 1 Stuck
DTC B3642 A5: : Wiper Switch Down F 2 Stuck
Circuit/System Description
The Steering Wheel Module (SWM) contain switches that control the Front and rear wiper and washer functions. These switches are integrated within the SWM and are not serviceable as a separate component. The SWM monitors these switch inputs for internal faults and set DTC B3637 A5 through DTC B3642 A5 if any are detected.
Conditions for Running the DTC
The system voltage is 9-18 volts.
Conditions for Setting the DTC
The SWM detects multiple or simultaneous switch inputs from a wiper or washer switch for more than one minute that would indicate a stuck switch.
Action Taken When the DTC Sets
The SWM ignores inputs from the malfunctioning switch.
Conditions for Clearing the DTC
| • | The DTC will be current for as long as the fault is present. |
| • | When the fault is no longer present, the DTC will be a history DTC. |
| • | A history DTC will clear after 40 ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Wiper/Washer System Description and Operation
or
Rear Wiper/Washer System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Clear all DTCs and operate the integrated switches at SWM within the Conditions for Running the DTC. The DTC should not set.
| ⇒ | If the DTC sets, replace the SWM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
For Steering Wheel Module replacement, setup, and programming.
