Rearview Mirror Support Installation with Rainsensor
Removal Procedure
- Remove the inner rearview mirror from the retaining plate.
• | Release the rain sensor cover. |
• | Disconnect the wiring harness plug (1). |
• | Compress the clamp (2) and pull the mirror downwards to remove. |
- Clean the windshield in the area to be cemented with glass cleaner.
- Place masking tape around the area on the windshield where the retaining plate is to be cemented.
Gently sand the retaining plate (grain P100) and clean.
Installation Procedure
- Affix the retaining plate.
• | Mix the 2-component adhesive GM P/N 89021329 (Canadian P/N 89020893) in accordance with the instructions and apply to the retaining plate approximately 1 mm (0.039 in) thick. |
• | Only press the retaining plate lightly onto the windshield. |
• | Fasten the retaining plate. Retaining plate position: |
- | I = 20 mm (0.78 in) from edge of molded headlining. |
- | II = middle windshield. |
- Install the interior rearview mirror.
2.1. | Replace the mirror and listen for the click. |
2.2. | Connect the wiring harness plug. |
2.3. | Install the rain sensor cover. |
Rearview Mirror Support Installation without Rainsensor
Removal Procedure
- Detach the inside rearview mirror.
Unlock the mirror downward and remove.
- Clean the windshield in the area to be cemented with glass cleaner.
- Place the masking tape around the area on windshield where the retaining plate is to be cemented.
Gently sand the retaining plate (grain P100) and clean.
Installation Procedure
- Affix the retaining plate.
• | Mix the 2-component adhesive GM P/N 89021329 (Canadian P/N 89020893) in accordance with the instructions and apply to the retaining plate approximately 1 mm (0.039 in) thick. |
• | Only press the retaining plate lightly onto the windshield. |
- Attach the interior rearview mirror.
- Replace the mirror and listen for the click.