Removal Procedure
- Remove the panel for the microphone (2) and the panel for the sliding sun roof control unit (3).
Release using a suitable tool (screwdriver).
- Release the lens from the interior lamp (1).
- Remove the front interior lamp holder.
• | Remove the 2 bolts (1). |
• | Release the holders (4) all around. |
• | Release the wiring harness holder (2). |
• | Disconnect the wiring harness plug (3). |
- Remove the microphone.
• | Disconnect the compact plug (1). |
• | Release and disconnect the wiring harness at the compact plug (arrow). |
• | Disconnect and remove the microphone (2). |
Installation Procedure
- Install the microphone.
• | Install in the microphone. |
• | Connect the wiring harness plug. |
• | Connect the compact plug. |
Notice: Refer to Fastener Notice in the Preface section.
- Install the interior lamp holder.
• | Install the 4 retaining lugs. |
Tighten
Tighten the 2 screws to 2.5 N·m (22 lb in).
• | Connect the wiring harness plug into the holder. |
• | Connect and lock the 2 wiring harness plugs. |
- Install the panel for the sunshade actuation switch.
- Install the microphone cover.
- Install the lens for the front interior lamp.