For 1990-2009 cars only
Removal Procedure
- Open the instrument panel (I/P) compartment to a full down position.
- Disconnect the radio antenna cable (2) from the radio extension cable.
- Remove the lower rear portion of the wheelhouse panel. Refer to Wheelhouse Panel Replacement.
- Reach up behind the wheelhouse panel and remove the antenna cable and grommet assembly from the cowl opening (1).
- Pass the end of the radio antenna cable assembly through the cowl opening (1).
- Remove the antenna mast. Refer to Fixed Antenna Mast Replacement.
- Open the hood.
- Remove the radio antenna cable assembly retaining screws.
- Pass the antenna cable and grommet assembly through the fender opening.
- Remove the radio antenna cable assembly from the vehicle.
Installation Procedure
- Install the radio antenna cable assembly to the vehicle.
- Pass the antenna cable and grommet assembly through the fender opening.
- Install the radio antenna cable assembly retaining screws and tighten to 2.8 N·m (25 lb in).
- Close the hood.
- Install the antenna mast. Refer to Fixed Antenna Mast Replacement.
- Reach up behind the wheelhouse panel and pass the end of the radio antenna cable assembly through the cowl opening (1).
- Install the antenna cable grommet assembly to the cowl opening.
- Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement.
- Install the radio antenna cable (2) to the radio extension cable.
- Close the I/P compartment.
Caution: Refer to Fastener Caution in the Preface section.
