Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Recover the refrigerant. Refer to
Refrigerant Recovery and Recharging
.
- Remove the screw that secures the receiver-dryer band clamp.
- Remove the receiver-dryer with the bolts.
- Drain the oil from the receiver-dryer into a container. Measure the amount of oil drained from the receiver dryer and then discard this used oil.
Installation Procedure
Important: Do not uncap the new unit until just prior to installation.
- Add oil to the new receiver-dryer. Use the exact amount of oil that you drained from the receiver-dryer.
- Install new O-rings in the seal area recess of the new receiver-dryer.
- Install the receiver-dryer into the clamp position.
Notice: Refer to Fastener Notice in the Preface section.
- Install the connector block retaining bolt to the receiver-dryer.
Tighten
Tighten the receiver-dryer bolt to 14 N·m (10 lb ft).
- Install and tighten the band clamp bolt.
- Connect the negative battery cable.
- Evacuate and recharge the A/C system. Refer to
Refrigerant Recovery and Recharging
.