GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2008 🢒 Vibe - FWD 🢒 Suspension 🢒 Tire Pressure Monitoring 🢒 Tire Pressure Indicator Receiver Replacement

Removal Procedure
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the headlining trim panel. Refer to Headlining Trim Panel Replacement .

    3. Object Number: 1954520 Size: SH
  3. Remove the bolt from the tire pressure monitoring receiver (1).

    4. Object Number: 1954522 Size: SH
  4. Disconnect the connector (1).
  5. Remove the receiver (2) from the vehicle.

Installation Procedure

    Object Number: 1954523 Size: SH
  1. Connect the connector to the tire pressure monitoring receiver (4).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the receiver and the bolt (3). Engage the 2 tabs (1, 2) into the holes.

    3. Tighten
    Tighten the bolt to 7.5 N·m (66 lb in).

  3. Install the headlining trim panel. Refer to Headlining Trim Panel Replacement .
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Initialize the system. Refer to Tire Pressure Monitor System Configuration .