GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2008 🢒 Vibe - FWD 🢒 Suspension 🢒 Tire Pressure Monitoring 🢒 Low Tire Pressure Indicator Module Replacement

Removal Procedure
  1. Read the registered transmitter identification (ID) numbers. Write down the numbers in order to aid the re-registration of the ID numbers in the new module. Refer to Tire Pressure Sensor Learn .
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the upper instrument panel assembly. Refer to Instrument Panel Upper Trim Pad Replacement .

    4. Object Number: 1954784 Size: SH
  4. Remove the screw from the tire pressure indicator module (1).

    5. Object Number: 1954793 Size: SH
  5. Disconnect the connector (2).
  6. Remove the tire pressure indicator module (1).

Installation Procedure

    Object Number: 1954799 Size: SH
  1. Connect the connector to the tire pressure indicator module (4).
  2. Engage the tab (2) into the hole (1) and install the module.
  3. Install the screw (3).
  4. Install the upper instrument panel assembly. Refer to Instrument Panel Upper Trim Pad Replacement .
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  6. Measure the tire pressure of each of the tires. Adjust the tire pressure to the specification on the tire placard, if necessary.
  7. Register the transmitter ID numbers for all of the tires. Refer to Tire Pressure Sensor Learn .
  8. Initialize the system. Refer to Tire Pressure Monitor System Configuration .