For 1990-2009 cars only
Removal Procedure
- Remove the front side door water deflector. Refer to Front Side Door Water Deflector Replacement .
- Remove the 3 screws (1) and the access shield (2) from the door (3), if equipped.
- Remove the 2 window-to-regulator bolts (2).
- Remove the window (1) by pulling up and out of the door.
Installation Procedure
- Install the window (1) to the door. Secure the window to the regulator with 2 bolts (2).
- Install the access shield (2) to the door (3), if equipped. Secure the shield with the 3 screws (1).
- Install the front side door water deflector. Refer to Front Side Door Water Deflector Replacement .
Notice: Refer to Fastener Notice in the Preface section.
Important: Before installing the window into the door, check to see that the bottom channels are securely attached to the window. If a channel is loose, note the location of the channel on the window and then remove the channel from the window. Clean all remaining adhesive from the channel. Apply a bead of Automix Channel Bonding and Sidelite Adhesive, 3M P/N 08641, or equivalent, to the channel and install the channel onto the window. Refer to adhesive manufacturer's instructions for cure time.
Tighten
Tighten the window-to-regulator bolts to 8 N·m (71 lb in).
