Accelerator Pedal Position Sensor Replacement FWD

Important: Do not remove the accelerator pedal position (APP) sensor from the accelerator pedal assembly. The APP sensor and pedal assembly are serviced as one unit.

Important: Do not attempt to adjust the APP sensor. The APP sensor calibration is preset at the factory.




1. Disconnect the electrical connector (2) from the APP sensor (1).
2. Remove the 2 fasteners (3) and the APP sensor and pedal assembly (1).

1. Install the APP sensor and pedal assembly (1) to the vehicle.
2. Secure the accelerator pedal assembly to the vehicle with 2 fasteners (3).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten
Tighten the 2 fasteners to 5 N·m (44 lb in).

3. Connect the electrical connector (2) to the APP sensor (1).