Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Remove the front fascia extensions, if equipped. Refer to Front Bumper Fascia Extension Replacement in Bumpers.



2. Remove the front fender liners. Refer to Wheelhouse Panel Replacement in Body Front End.
3. Remove the fog lamps. Refer to Front Fog Lamp Replacement in Lighting Systems.
4. Remove the bolts (4) from the front bumper fascia (3) at the fender.
5. Remove the push-in retainers (2) from the bumper fascia using J 38778 .
6. Remove the fascia bolts (1) from the fascia.
7. Remove the fascia from the vehicle.
8. Remove the grilles from the fascia. Refer to Fascia Grille Replacement .



9. Remove the 10 screws from the upper and lower fascias.

1. Assemble the upper and lower fascias with the 10 screws.
2. Install the grilles. Refer to Fascia Grille Replacement .
3. Position the fascia to the vehicle.



4. Install the bolts (1) to the fascia (3).
5. Install the push-in the retainers (2) to the front bumper fascia .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the bolts (4) to the front fascia (3) at the front fenders.

Tighten
Tighten the front fascia bolts to 2 N·m (18 lb in).

7. Install the fog lamps. Refer to Front Fog Lamp Replacement in Lighting Systems.
8. Install the front fender liners. Refer to Wheelhouse Panel Replacement in Body Front End.
9. Install the front fascia extensions, if removed. Refer to Front Bumper Fascia Extension Replacement in Bumpers.