Fore-aft adjustment may be made by moving the hood within the elongated hinge holes.

Vertical adjustment at the front may be made by adjusting the hood bumpers up or down.

1. Raise the hood.
2. Support the hood.
3. Loosen the hood (1) mounting bolts.

Notice: Refer to Fastener Notice in the Preface section.

4. Adjust the hood to the front fender clearance gap to between 2.5-5.5 mm (0.10-0.22 in) on each side of the hood. Tighten the hood mounting bolts.

Tighten
Tighten the hood mounting bolts to 13 N·m (9 lb ft).

5. Remove the hood support.
6. Lower the hood.

1. Raise the hood.
2. Rotate the hood bumpers (1).



3. Adjust the height of the hood bumpers (1) until hood front clearances are flush at a measurement of within -1.5 to +1.5 mm (-0.06 to +0.06).
4. Lower the hood.