For 1990-2009 cars only
Removal Procedure
- Open the hood.
- Remove the rubber cover and socket from the headlamp.
- Release the retainer clip (1) holding the bulb (2) by pressing down and moving the metal retainer away from the composite headlamp (3).
- Remove the bulb (2) from the composite headlamp (3), if necessary.
- Remove the front fascia. Refer to Front Bumper Fascia Replacement .
- Remove the 3 bolts which secure the composite headlamp.
- Remove the sidemarker bulb electrical connector.
- Remove the sidemarker bulb, if necessary.
- Remove the composite headlamp assembly from vehicle.
Caution: Refer to Halogen Bulb Caution in the Preface section.
Installation Procedure
- Install the sidemarker bulb to the composite headlamp, if removed.
- Connect the sidemarker bulb electrical connector.
- Secure the composite headlamp to the vehicle with the 3 bolts .
- Install the front fascia. Refer to Front Bumper Fascia Replacement .
- Install the headlamp bulb (2) to the composite headlamp (3), if removed.
- Fasten the headlamp bulb retainer clip (2).
- Install the socket to the headlamp bulb.
- Install the rubber cover to the composite headlamp.
- Aim the headlamps. Refer to Headlamp Aiming .
- Close the hood.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the headlamp mounting bolts to 10 N·m (89 lb in).
