Preliminary Procedures

1. Open the hood.
2. Release the connector positive assurance (CPA) connector at the headlamp connector.
3. Disconnect the electrical harness from the headlamp assembly prior to removal.

1

Headlamp Screw (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tip
Hold the lamp assembly to the hood when removing the screws.

Tighten
9 N·m (80 lb in)

2

Headlamp Assembly

Tip
Adjust the headlamps after servicing the headlamp assembly. Refer to Headlamp Aiming .

Preliminary Procedures

1. Open the hood.
2. Release the connector position assurance (CPA) connector at the headlamp bulb socket.
3. Disconnect the electrical harness from the left side headlamp prior to removal.

1

Headlamp Assembly Socket

Tip
Disengage the bulb socket from the headlamp assembly by rotating one quarter turn counterclockwise.

2

Headlamp Screws (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tip
Hold the lamp assembly to the hood when removing the screws.

Tighten
8 N·m (71 lb in)

3

Headlamp Assembly

Tip
On the left front headlamp assembly, disconnect the electrical harness from the rear of the headlamp composite.