Tools Required

J 45059 Angle Meter

1. Install the flywheel.
2. Install the NEW bolts.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Hold the crankshaft.

Tighten
Tighten the bolts to 53 N·m (39 lb ft), plus 25 degrees using the J 45059 .