GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 Solstice 🢒 Engine 🢒 Engine Mechanical - 2.4L 🢒 Engine Oil and Oil Filter Replacement

Removal Procedure

    Object Number: 758466 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Place a drain pan under the oil drain plug.
  3. Remove the oil pan drain plug.
  4. Allow the oil to drain completely.

    5. Notice: Refer to Fastener Notice in the Preface section.

  5. Install the oil pan drain plug.

    6. Tighten
    Tighten the plug to 25 N·m (18 lb ft).


    Object Number: 1578313 Size: SH

    Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.

  6. Use a 32 mm (1 1/4 in) socket on the hex on top of the oil filter cap, or an oil filter wrench on the outside diameter of the oil filter cap.
  7. Remove the oil filter cap and filter.

    8. Object Number: 1714432 Size: SH
  8. Remove the oil filter from the oil filter cap.
  9. Inspect the oil filter cap O-ring seal for damage, replace as necessary.

Installation Procedure

    Object Number: 1714432 Size: SH
  1. Install a NEW oil filter to the oil filter cap.

    2. Object Number: 1578313 Size: SH
  2. Install the oil filter cap and filter.

    3. Notice: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.

    Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.

  3. Use a 32 mm (1 1/4 in) socket on the hex on the top of the oil filter cap, or an oil filter wrench on the outside diameter of the oil filter cap .

    4. Tighten
    Tighten the oil filter cap until fully seated. DO NOT exceed 25 N·m (18 lb ft).

  4. Lower the vehicle.
  5. Fill the engine with oil. Refer to Fluid and Lubricant Recommendations .