Callout
| Component Name
|
Preliminary Procedures
- Remove the instrument panel (I/P) lower closeout panel. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
.
- Remove the accelerator pedal assembly with bracket from the brake pedal bracket to improve access to the brake pedal pivot nut. Refer to
Accelerator Pedal Position Sensor Replacement
.
- Remove the clutch pedal assembly, if equipped, for removal of the brake pedal pivot bolt. Refer to
Clutch Pedal Replacement
.
|
1
| Clip, Vacuum Brake Booster Pushrod
|
2
| Washer, Vacuum Brake Booster Pushrod
|
3
| Bolt, Brake Pedal Pivot
|
4
| Nut, Brake Pedal Pivot
Notice: Refer to Fastener Notice in the Preface section.
Tighten
50 N·m (37 lb ft)
Tip
Hold the brake pedal pivot bolt stationary and tighten the brake pedal pivot nut. Do not tighten the bolt. |
5
| Pushrod, Vacuum Brake Booster
|
6
| Pedal, Brake
Tip
| • | Apply a thin coat of high-temperature grease GM P/N 12345996 (Canadian P/N 10953501) to the brake pedal pivot bushing, the pushrod washer, the push rod pin on the pedal, and the brake pedal pivot pin. |
|
