Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Caution: Refer to SIR Caution in the Preface section.

Preliminary Procedures

1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
2. Remove the rear window panel trim. Refer to Rear Window Panel Trim Replacement .
3. Remove the floor console. Refer to Front Floor Console Replacement .
4. Program the inflatable restraint sensing and diagnostic module after replacement. Refer to Control Module References .

1

Inflatable Restraint Sensing and Diagnostic Module Nut (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
10 N·m (88 lb in)

2

Inflatable Restraint Sensing and Diagnostic Module Assembly