Special Tools
• | J 28467-B
Universal Engine Support Fixture |
Installation Procedure
- Remove the left bank ignition coils. Refer to
Ignition Coil Replacement.
- Install
J 42451-1
bracket, using M10 bolts onto the left front of engine.
- Install the
J 28467-501
(1, 7) onto fender rails near the strut towers.
- Install the J 28467-3 cross car tube (2) to the
J 28467-501
(1, 7).
- Install the J 28467-2A radiator shelf tube on top of the J 28467-3 cross car tube (2).
- Install the round tube of the J 28467-4A front support assembly (4) through the large hole in the J 28467-2A radiator shelf tube. The hole used in the J 28467-2A radiator shelf tube (5) depends on the vehicle
application.
- Place the rubber padded foot of the J 28467-4A front support assembly on the upper tie bar.
- Install the J 28467-9 7/16-inch x 2.0-inch quick release pin through the hole in the J 28467-4A front support assembly in order to level the J 28467-2A radiator shelf tube.
- Install the J 28467-7A lift hook through the J 28467-6A lift hook bracket (5).
- Install the J 28467-6A assembled lift hook bracket (6) over the J 28467-3 strut tower tube (2).